top of page
Search

Warehouse Water Hygiene: A Legionella Guide for UK Operators

3 hours ago
9 min read

Long water pipes serving a warehouse washroom

Warehouse water hygiene is the management of the water systems in your building so that Legionella and other bacteria cannot grow and reach people. It is a legal duty, not a cleaning job. If you employ staff or control the premises, you must assess the risk, control it and keep records. A competent, accredited specialist that carries out the risk assessment, sampling and remedial work is the simplest way to meet that duty across one site or many, and that is what we do at Bespoke Compliance Solutions.



TL;DR

 

  • Warehouse water hygiene means controlling Legionella risk in hot and cold water, showers, tanks, emergency eyewash and similar systems. It is not floor cleaning or general sanitation.

  • Employers and people in control of premises, including landlords, must assess the risk, manage it and keep records under HSE guidance.

  • A written risk assessment by a competent person comes first. Routine temperature checks, flushing and sampling follow, at the frequency the assessment sets.

  • Reassess when the system, the building use or key staff change, and after any case of Legionnaires’ disease.

  • Our Legionella risk assessments start from £185 and our water testing from £55 per sample.

 

Table of Contents

 

 

What water hygiene means in a warehouse

 

Search for this topic and most results are about sweeping, pressure washing and pest control. Those matter for housekeeping. Water hygiene is a different subject: the safety of the water that runs through your pipes, tanks and outlets.

 

The main hazard is Legionella, the bacteria behind Legionnaires’ disease, a serious form of pneumonia. HSE explains that a reasonably foreseeable risk exists where water is between 20 and 45°C, where droplets can be created and breathed in, where water is stored or recirculated, and where nutrients such as scale, rust or sludge are present.

 

A warehouse can tick several of those boxes. Think of a cold water storage tank on the roof, a hot water cylinder serving a canteen, showers for drivers and pickers, or a washroom block at the far end of a long pipe run that few people use.

 

Which warehouse systems carry risk

 

HSE lists cooling towers, evaporative condensers, hot and cold water systems and spa pools among the most common man-made sources. It also names humidifiers, air washers, emergency showers and indoor ornamental fountains. In a typical distribution or storage building the ones to look at are:

 

  • Cold water tanks. Large volumes, slow turnover and warm roof spaces let water drift above 20°C.

  • Hot water cylinders and calorifiers. Stored water that is not kept hot enough gives bacteria a home.

  • Showers and spray taps. They create the breathable droplets that carry bacteria into lungs.

  • Infrequently used outlets. Washrooms in unused mezzanines, spare offices or sections of the building closed for part of the year.

  • Dead legs. Redundant pipework left after refits, which holds stagnant water. HSE advises removing dead legs and dead ends and keeping pipework short and direct.

  • Emergency eyewash and safety showers. These sit idle for long periods unless they are flushed on a schedule.

  • Humidifiers and air-handling plant in temperature-controlled or chilled areas.

 

Not every warehouse is high risk. The HSE’s approved code of practice, ACOP L8, gives an example of a low-risk situation: a small building where daily use turns over the whole system, cold water comes straight from the mains with no storage tank, hot water comes from instantaneous or low-volume heaters at 50°C, and the only outlets are toilets and hand basins with no showers. Many warehouses with tanks, showers or large pipe runs fall outside that description, so the assessment has to say so on paper.

 

Who is responsible

 

HSE states that employers and people in control of premises, including landlords, must identify and assess sources of risk, manage the risks, prevent or control them and keep the correct records. The Health and Safety at Work etc. Act, the Management of Health and Safety at Work Regulations and COSHH all apply, and ACOP L8 is the practical guidance.

 

This matters in warehousing because control is often split. The tenant runs operations, the landlord keeps the plant, and a third-party logistics firm may share the space. ACOP L8 defines the dutyholder as the employer, the self-employed person or the person in control of premises, for example a landlord who keeps maintenance responsibility for a building let to tenants. Settle in writing who holds each duty, and name a responsible person for each site.

 

The Ministry of Defence’s JSP 375 Chapter 32, version 1.4 published on 1 October 2025, restates the wider framework. Legionella is covered as a hazardous substance under COSHH 2022, RIDDOR requires legionella exposure to be reported as an occupational disease, and the Health Protection (Notification) Regulations 2010 require laboratories and doctors to notify cases to the local authority.

 

Step 1: a written risk assessment

 

ACOP L8 requires a suitable and sufficient assessment by a competent person. It must identify and evaluate sources of risk and the measures that prevent or control exposure. Three points decide whether yours is any good.

 

A schematic of the system. ACOP L8 calls a schematic diagram showing the layout, including parts temporarily out of use, an important tool for the assessment. In a warehouse that has been extended or reconfigured over years, the drawing often does not match the pipework. Walking the system is where unknown tanks and dead legs turn up.

 

The people exposed. The assessment weighs the number of people exposed and how susceptible they are. HSE says to consider staff susceptibility, including age, illness, smoking, alcohol and a weakened immune system.

 

A record. Where you have five or more employees, the significant findings must be recorded. You must also consult employees or their representatives on the risks and control measures.

 

You may use outside help. ACOP L8 says the dutyholder can use a consultancy, a water treatment company or an experienced assessor, but must make reasonable enquiries to be sure they are competent. Our assessments are written for the specific site and start from £185, delivered by accredited specialists with full documentation. See our Legionella risk assessment service.

 

Step 2: put a written control scheme in place

 

Where a risk is reasonably foreseeable, ACOP L8 says exposure must be avoided so far as reasonably practicable, or a written scheme for controlling it must be produced, implemented and managed. For a warehouse the scheme normally covers temperature, turnover and cleanliness.

 

HSE’s technical guidance sets out the targets:

 

 

Where the system uses copper and silver ionisation or biocides such as chlorine dioxide, HSE says these need assessment as part of the overall water treatment programme.

 

Step 3: routine checks and records

 

The scheme only works if someone does the checks and writes them down. HSE’s guidance sets this rhythm:

 

Task

Frequency

Temperature at sentinel outlets (furthest and nearest to each tank or cylinder)

Monthly

Hot water cylinder temperatures

Monthly

Cold water tank temperatures

At least every 6 months

Flushing infrequently used outlets

At least weekly

Cleaning and descaling showerheads

At least quarterly

Water sampling for Legionella

At a frequency set by the risk assessment

These frequencies come from HSE’s guidance on managing legionella in hot and cold water systems, and the monitoring and record requirements from HSG274 Part 2. That guidance expects records of every inspection, including the surveyor’s verified name, date and sample location.

 

Two things go wrong most often. First, checks are done by whoever is free that week, with no training. Our Legionella awareness training is available on-site or online, so site teams know what they are checking and why. Second, a missed month is not noticed until an audit. HSG274 Part 2 notes that building management systems are increasingly used for automated monitoring, giving early warning when the control regime fails. For a large or multi-site estate we offer automated water temperature monitoring, and a bespoke logbook system for the manual checks.

 

When to sample and test

 

HSE says water should be analysed for legionella periodically to show acceptable bacteria counts, and that the frequency depends on the risk assessment. Sampling confirms that the controls are working. It does not replace them.

 

The usual sampling points are the same sentinel outlets used for temperature checks. Beyond Legionella, warehouses with food areas, staff kitchens or drinking water points may also want potable water, microbiological, TVC or Pseudomonas testing. Closed heating and chilled systems have their own water-quality tests. Our water testing and analysis covers these, with Legionella sampling from £55 per sample.

 

If a result is outside the acceptable range, the next move is corrective action: re-sampling, then cleaning and disinfection of the affected system. Our tank cleaning and system disinfection service covers tank cleaning, disinfection, tank repair or replacement and ongoing maintenance contracts. We also carry out TMV servicing and general remedial works under our compliance services.


When to sample and test

When to review the assessment

 

An assessment is not a one-off. ACOP L8 says it must be reviewed regularly, and specifically when there is reason to believe it is no longer valid: changes to the water system or its use, changes to building use, new risk information, changes to key personnel, or a case of legionella. HSE also names expansion of the water system as a trigger.

 

In warehousing, the typical triggers are an extension, a new mezzanine with welfare facilities, a change of tenant, a section mothballed for a season, or a new canteen. Build the review trigger into the document itself, as ACOP L8 intends. Our guide to reviewing a Legionella risk assessment explains what a review should cover.

 

A practical starting plan for a facilities manager

 

  1. List every site and who is the dutyholder for each, tenant or landlord.

  2. Gather drawings, and note every tank, cylinder, shower, eyewash and rarely used outlet.

  3. Commission a risk assessment from a competent, accredited assessor and record the findings.

  4. Set up the written scheme: temperatures, flushing, descaling, sampling frequency.

  5. Train the people who do the checks, and keep a logbook or automated record.

  6. Diarise reviews and the trigger events above.

 

If you manage several sites, our method of works page shows how we deliver this consistently.

 

Our approach to warehouse water hygiene

 

We treat every warehouse as its own system. Two buildings of the same size can have completely different risk, because one has a roof tank and showers and the other has mains-fed toilets only.   Our goal is to make compliance simple. That means a bespoke risk assessment, a control programme your team can actually follow, a logbook system that holds the records, and training so the person doing the monthly check understands what the numbers mean.   We work in partnership with you across the UK, so that your knowledge and your on-site compliance improve over time, not just on the day of the survey.   Sammi

 

Getting your sites assessed

 

We provide Legionella risk assessments from £185, water sampling from £55 per sample, awareness training, monitoring, remedial works and ongoing consultancy for commercial and industrial premises across the UK. Quotes and reports are turned around quickly, and every job comes with full documentation.

 

[


Bespokecompliancesolutions

 

Start with a Legionella risk assessment for your warehouse, or see the full range on our homepage.

 

FAQ

 

Does every warehouse need a Legionella risk assessment?

 

If you are an employer or control the premises, you must assess the risk from Legionella. Only simple systems qualify as low risk under ACOP L8, such as mains-fed toilets and basins with no tanks or showers. Even then, the conclusion should be recorded.

 

How often should warehouse water be tested for Legionella?

 

HSE says the frequency of water sampling is set by the risk assessment. Temperature checks and flushing happen far more often, monthly and weekly respectively, and sampling confirms they are working.

 

Who is responsible if the warehouse is leased?

 

The dutyholder is the employer, or the person in control of the premises or system. A landlord who keeps maintenance responsibility is a dutyholder alongside the tenant who employs the staff. Agree and record who does what.

 

Can we do the checks ourselves?

 

Yes, if the people doing them are trained and competent, and the results are recorded. HSE guidance accepts monitoring by trained staff or automated systems. Our training and monitoring services support both.

 

Sources

 

Recommended

 

 
 
 

Comments


bottom of page