top of page
Search

Leisure Centre Water Hygiene: A Duty Holder's Guide

6 minutes ago
10 min read

Technician sampling an active leisure centre spa pool

A leisure centre runs several water systems under one roof: pools, spa pools, showers, cold water tanks and hot water services. Each is managed under a different standard. Good water hygiene means knowing which standard applies to which system, writing the controls into a Legionella risk assessment, testing on schedule and keeping records that show it. We carry out Legionella risk assessments and water sampling for sites across the UK, and this guide sets out what a facilities or compliance manager needs to have in place.



TL;DR

 

  • There is no pool-specific health and safety law. Your duties come from the Health and Safety at Work etc Act 1974 and related regulations, with HSE and PWTAG guidance setting the standard.

  • Spa pools sit under HSG282, not the PWTAG pool code. They need monthly microbiological sampling and quarterly Legionella sampling.

  • Showers, tanks and hot and cold services need a written Legionella risk assessment and a competent responsible person.

  • Records, staff training and a documented response to failed results are what an inspector or investigator will ask to see.

  • Sampling must follow BS 7592 and be analysed by a UKAS-accredited laboratory.

 

Table of Contents

 

 

What water hygiene covers in a leisure centre

 

Think in systems rather than in one pool. A typical centre may hold:

 

 

The reason to map all of this first is simple. A pool operator who is meticulous about chlorine readings can still have a shower block with rarely used outlets that sit stagnant for weeks.

 

Your legal duties as the dutyholder

 

HSE states that there are no specific health and safety laws for swimming pools. Operators must comply with the general duties under the Health and Safety at Work etc Act 1974 and associated regulations, and must make a suitable and sufficient risk assessment covering workers and users. The same page notes that PWTAG guidance on pool water quality and treatment is regarded by HSE and local authorities as the standard to be achieved in an effectively managed pool.

 

For Legionella, the key document is HSE’s L8 Approved Code of Practice. It applies where water is used or stored and there is a way of creating and transmitting inhalable droplets, and it requires that where a reasonably foreseeable risk exists, a written scheme for controlling it is properly implemented and managed. The technical detail sits in HSG274 Part 2, which explains that the legal framework rests on the 1974 Act, the Management of Health and Safety at Work Regulations 1999 and COSHH 2002. Its central duties are the risk assessment and the appointment of a competent responsible person. It also notes that external appointment may be needed where in-house competence is lacking.

 

In practice that means a named person at your organisation who understands the systems, has the authority to act and is trained. If that person is a general manager with a hundred other tasks, the written scheme tends to drift. Many centres therefore bring in outside expertise for the assessment and for ongoing support.


Your legal duties as the dutyholder

Building the Legionella risk assessment

 

According to HSG274 Part 2, the assessment and written scheme should cover:

 

  1. Allocation of management responsibilities.

  2. Competence and training of key personnel.

  3. An up-to-date schematic diagram of the water systems.

  4. Safe operating procedures.

  5. Monitoring, inspection and maintenance procedures, with results of checks.

  6. Known limitations of the system.

  7. Arrangements for regular review.

 

The controls the guidance then points to include controlling spray release, avoiding stagnation and microbial growth, keeping systems clean, treating the water, monitoring the controls and keeping records. L8 adds that water temperatures between 20°C and 45°C should be avoided, along with stagnation that encourages biofilm and materials that harbour bacteria. Biofilm is the slimy layer of microorganisms that lines pipework and shelters Legionella from disinfectant.

 

A leisure centre assessment should look at the particular features of the building: seasonal closures, outlets used only by occasional hirers, dead legs left by refurbishments, and the spa or sauna suite that may be used heavily one day and not at all the next. We build assessments around the site’s actual use and then implement the control programme and logbook system that follows from it, so the written scheme is a working document rather than a file on a shelf. Assessments start from £185. Once in place, the assessment is not static: our guide to reviewing a Legionella risk assessment covers when it must be revisited, such as after changes to the system or the building’s use.

 

Testing and monitoring: what, and how often

 

Different systems have different regimes. The table summarises what the official and professional guidance says.

 

System

What is checked

Frequency

Standard

Spa pools

ACC (aerobic colony count), coliforms, E. coli, P. aeruginosa

At least monthly

Spa pools

Legionella

At least quarterly

HSG282

Other open systems

Legionella

At least quarterly, more often where circumstances require

Swimming pools

Disinfectant residual and pH, continuous instruments checked daily against manual tests

Daily check

Hydrotherapy pools and treadmills

Free and total chlorine or bromine, pH, temperature

At least three times in an eight-hour day

How samples must be taken

 

HSG282 requires spa-pool samples to be taken while the pool is in use, preferably when heavily loaded or just afterwards, in line with BS 7592 and analysed by a UKAS-accredited laboratory working to EN ISO 17025. HSE’s guidance adds that the laboratory should take part in a water microbiology proficiency scheme such as the one run by UKHSA, and that culture-based methods should detect no more than 100 Legionella bacteria per litre at their minimum limit.

 

Those conditions matter. A sample taken from a quiet pool at seven in the morning, or sent to a laboratory without the right accreditation, can leave you with a result that does not stand up. Our Legionella water testing and analysis service starts from £55 per sample. It also covers microbiological testing, Pseudomonas aeruginosa, TVC, chemical testing, and pH and conductivity. To make sense of a lab report once it arrives, see our guide on how to interpret Legionella water samples.

 

Pools and routine Legionella testing

 

NARCH notes that pools and treadmills do not need routine Legionella testing provided a risk assessment has been carried out, while a spa or hot tub sample should be sent for Legionella testing. This is why the risk assessment comes first: it decides which systems need a sampling schedule and which are controlled by temperature, flow and treatment.

 

NARCH also gives practical water-balance points. If total dissolved solids exceed 1500 mg/l in spa or treadmill water, metal parts rust faster, and low calcium hardness makes water corrosive while high calcium hardness causes scale. Both are the kind of chemistry that conductivity and chemical testing help you spot early.

 

Temperature monitoring for showers and hot water

 

For non-pool outlets, control relies on keeping hot water hot and cold water cold, and on flushing little-used outlets. In a large centre, manual temperature checks across dozens of outlets are time-consuming. Our automated water temperature monitoring gives continuous readings so deviations are visible between visits. TMVs, which blend hot and cold water at the tap or shower, also need regular servicing as part of the control scheme, and we provide TMV servicing.

 

Records, responsibilities and training

 

Inspectors, insurers and investigators judge a centre largely on its paperwork. PWTAG requires pool management to monitor, as a minimum, plant and treatment logs, pool water testing, bacteriological monitoring and its interpretation, feedback from regulators and users, corrective and preventive actions, incident responses and staff training. Its code also asks that calibration records for test equipment be retained on log sheets, and that documented procedures cover test-kit use with full operator training.

 

For spa pools, the HPA and HSE guidance on spa pool management makes the spa pool manager responsible for ensuring control measures are used properly and not undermined by other work practices. Staff must follow standard operating procedures, wear PPE correctly, keep to high personal hygiene and report defects promptly.

 

Two practical points follow:

 

  • Make the logbook usable. A logbook that a lifeguard or technician can complete in a minute gets completed. We implement a bespoke logbook system matched to the site’s outlets and routines.

  • Train the people who do the checks. Staff who flush showers, read temperatures or run test kits need to understand why. Our Legionella awareness training is available on site or online.

 

When results fall outside limits

 

HSG282 expects the written scheme to state in advance what happens when monitoring shows controls are not working: the remedial action, the response to repeated adverse results or contamination incidents, and the criteria for closing and reopening a spa pool. Additional microbiological sampling is required:

 

  • when a spa pool is first used or recommissioned;

  • after a report of ill health following use;

  • where there is doubt about the control regime;

  • after a contamination incident;

  • after changes to treatment or maintenance.

 

In an outbreak, meaning two or more associated cases, the appropriate agency takes further samples after discussion between the environmental health officer and the local Health Protection Team. For pools, PWTAG requires documented procedures telling operators what to do when water chemistry is below or above safe limits.

 

If Legionella has been found or suspected in showers, our article on the HSE actions for dutyholders after suspected Legionella in showers walks through the sequence. Where remediation is needed, we carry out system disinfection, tank cleaning and flushing, and general remedial works. Anyone with symptoms, or any suspected case linked to your site, should be reported to your local authority environmental health team and the Health Protection Team without delay.

 

Keeping up with guidance

 

PWTAG updated its Code of Practice in July 2025 to clarify instantaneous bathing load and circulation rate, according to its code of practice page. HSG274 Part 2 was published in its current form in 2024 and HSG282 in 2017. Check the latest editions when your written scheme is reviewed, and recheck after any pool plant change.

 

Support for leisure and sports sites

 

A leisure centre combines the most demanding water systems in one building, and the duties land on a small management team. We work with facilities managers, estate managers and compliance managers across the UK. For a centre, that typically starts with a Legionella risk assessment from £185, then sampling from £55 per sample, with training, logbooks and ongoing consultancy to keep it running. Our quotes and reports are turned around quickly, and documentation is comprehensive. To discuss your site, visit Bespoke Compliance Solutions.

 

[


Bespokecompliancesolutions

 

Our view: compliance that runs itself

 

Most leisure centre problems we hear about are not caused by a lack of effort. They come from a gap between a good assessment and daily routine. The pool plant is checked because everyone can see it. The showers, the seldom-used outlet in the staff area and the tank in the plant room are forgotten because nobody owns them.   Our goal is to make compliance simple. That means an assessment written for your actual site, a control programme and logbook your team can follow, testing at the right points, and training so the people on shift know what they are looking at. We work in partnership with you, and we stay on afterwards through ongoing consultancy so knowledge builds up inside your organisation.   If you manage a centre, start with a current assessment and a clear list of who does what. Everything else follows from that.   Sammi

 

FAQ

 

Do leisure centres need a Legionella risk assessment?

 

Yes, where there is a reasonably foreseeable risk. HSE’s L8 Approved Code of Practice applies where water is stored or used and droplets can be created, including spa pools and showers. The dutyholder must have a written scheme for controlling that risk and a competent responsible person to manage it.

 

How often should spa pool water be tested?

 

HSG282 requires microbiological sampling at least monthly for ACC, coliforms, E. coli and P. aeruginosa, and at least quarterly for Legionella. Samples should be taken while the pool is in use, in line with BS 7592, and analysed by a UKAS-accredited laboratory.

 

Do swimming pools need routine Legionella sampling?

 

NARCH guidance states that pools and treadmills do not need routine Legionella testing where a risk assessment has been carried out. They do need daily and in-day disinfectant and pH monitoring under the PWTAG Code. Spa and hot tub water should be sampled for Legionella.

 

Which guidance covers pool water quality?

 

The PWTAG Code of Practice is the benchmark. HSE says regulators regard it as the standard for an effectively managed pool. Spa pools are excluded from it and are covered by HSG282 instead.

 

Who can be the responsible person?

 

Someone competent, with enough training, knowledge and authority to manage the control scheme. HSG274 Part 2 notes that where this competence is not available in-house, an external appointment may be needed.

 

Sources

 

Recommended

 

 
 
 

Comments


bottom of page